The bucke truck equipped with overflow protection, emergency power, cylinder lock and other security devices to ensure safety operations. Cab for the single-row seat with bunk, comfortable driving. Therefore, the vehicle is an ideal multi-purpose aerial vehicles.

 The bucket truck hydraulic system designed advanced, with a safe and reliable tech. However,any equipments without maintenance could not kept the equipment in good working condition, the operation will potentially dangerous. So you are familiar with the equipment itself before the operating process goes. Any uncleared changes or operations for this bucket truck, you must immediately report to the superiors or notify the manufacturer

Structurer Components and Working Principles

1. PTO System

PTO system consisted of the oil pump ,PTO ,electrical control switches and pneumatic solenoid valve.The system working in output the power to oil pump storaged as a hydraulic energy. This system is controlled by a on/off switch that installed in the driving cab,through the interior of the switch’s joint or separation,lead the gear be driven from the transmission make the  pump stop or working.

2.Slewing Rotation System

Slewing rotary system consisted by the hydraulic motor, gera reducer ,slewing gear, etc. The system worked as: hydraulic motor drived  the reducer,the small gear, in reducer output shaft, drive the slewing ring move, and slew the saddle turnable.

3.Centre Slewing Joints

The centre slewing joints, installed in the center of rotatery saddble, Achieved the oil and electric power through the truck. As the system equipped with rotatery rings, the hydraulic oil pipes and electric wires would not twisted together.

 4.Hydraulic System

The hydraulic system hydr oil supplied by a pump, worked pressure at 14Mpa, flux as 25L/Min,the pressure adjustable by a overflow valve.

When the PTO coupling with the transmission ,the pump will in a situation of running,the oil output from the oil tank to all the legs which controlled by a controll valve equipped in the controll panel.

Finished leg operation, handle the operation poke into position marked as ,then,the oil would drived from leg system to “To arms” , and the upper control panel would be actived,then could start the next operation works.